For the testing of gas turbine and diesel engine filters, these are often tested according to Aramco standard 32-SAMSS-008. The Aramco test dust specified in the above standard is used for this purpose. The specification specifies that the particle size distribution of sodium chloride in the test dust must be between 0-5 µm. The DMT GmbH & Co. KG produces DMT Aramco test dust using a special process so that the sodium chloride, which can become highly agglomerated at normal air humidity and thus clearly > 5 µm, meets the given specification.
DMT beech wood dust is used to measure vacuum, cleaning interval and residual dust content according to DIN EN 16770. According to the specification, the median particle size is approx. 100 µm, whereby the d90 is between 20 - 300 µm. The wood moisture content is set between 6 - 10 %.
The cotton specially cut by DMT is part of the simulated house dust DMT test dust type 8® and is specified in IEC 62885 / IEC 60312 / DIN EN 60312. This cut cotton is also used as a pure component for various filter technology tests. (For fiber length distribution see standard) Since cotton is a natural product, the fiber structure and composition are subject to certain natural variations. DMT GmbH & Co. KG is accompanied by strict quality monitoring, which begins with the supplier to achieve a high batch to batch comparability. Our specifications must be strictly observed during storage. Increased humidity can greatly accelerate the natural decomposition process.
DMT Dolomit mineral dust, also known as hard floor dust or crevice dust, meets the specifications of the IEC 62885-2 / IEC 60312 / DIN EN 60312-1 Chap. 184.108.40.206. In addition to the fine fraction, DMT Dolomite mineral dust also contains coarse particles up to 2 mm in size. This composition is similar to the dust & sand found in reality on hard floors such as laminate, parquet or tiled floors. The corresponding standard test is described in Chapter 5, IEC 62885-2. This test dust is used to determine or evaluate the dust absorption of a vacuum cleaner on hard floors.
DMT mineral dust type 2 is produced in accordance with the IEC 62885 (2016) / IEC 60312 (2010) / DIN EN 60312 (2014) Chapter 220.127.116.11. The particle size range is between 90 µm - 200 µm. This mineral dust is used for dust absorption testing on carpets as described in Chapter 5, IEC 62885-2. (Reference to ISO 679 / CEM 1 Description ) With a particle size range between 90 - 200 µm it is possible that partial demixing may occur during transport. It is therefore recommended to homogenize DMT Carpet Mineral Sand Type 2 before use, which can be achieved by mixing it with a laboratory tumble mixer.